2024
29-06-2024
Thermo chemical conversion Technology
17
Total Questions
कुल प्रश्न
2024
1 Paper
Papers Covered
कुल पेपर्स
1 Exam Years
1 परीक्षा वर्ष
14.2%
Exam Weightage
परीक्षा वेटेज
In 2024 Exam
2024 परीक्षा में
5 Chapters
Syllabus Chapters
पाठ्यक्रम अध्याय
3 Question Types
3 प्रश्न प्रकार
Question Types:
प्रश्न प्रकार:
MCQ (Single Correct)
MCQ (एकल सही)
13
Match the Following
सूची मिलान
2
Statement Based
कथन आधारित
2
Previous Years Questions (PYQ) Statistics
विगत वर्षों के प्रश्न (PYQ) सांख्यिकी
Previous Years Questions (PYQ) Statistics विगत वर्षों के प्रश्न (PYQ) सांख्यिकी
Year-wise question count, paper frequency, and exam weightage percentage for Thermo chemical conversion Technology: Thermo chemical conversion Technology हेतु वर्षवार प्रश्नों की संख्या, पेपर आवृत्ति और परीक्षा वेटेज प्रतिशत:
| Year वर्ष | Questions प्रश्न | Avg / Paper औसत / पेपर | Weightage & Trend वेटेज व ट्रेंड |
|---|---|---|---|
| 2024 | 17 Qs | 17.0 |
All Questions in this Subject इस विषय के सभी प्रश्न
17 Questions 17 प्रश्न
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
Given below are two statements
Statement (I) : Hydrodynamic lubrication occurs when oil film is thick enough to prevent projections on one surface from
contacting those projections on the mating surface
Statement (II) : All bearings in an engine are in hydrodynamic lubrication when the engine is started from rest or when it is
coasting to a stop
In light of the above statements, choose the most appropriate answer from the options given below.
Range of aspect ratio for high molded tyres
Match List-I with List-II:
Choose the correct answer from the options given below:
Alinear reservoir is one in which storage is directly proportional to:
Given below are two statements
Statement (I) : A channel section is most economical when maximum discharge is obtained for a given cost of construction.
Statement (II) : Discharge is maximum when the flow velocity is minimum
In light of the above statements, choose the most appropriate answer from the options given below.
Following are the statements regarding sediment loads.
(A) . Bed load is associated with the movement of coarse particles along the bed surface through sliding, rolling and saltation
(B) . Bed load forms less than 25 % portion of total load
(C) . Suspended load of a stream is not measured by sampling the stream flow.
Choose the correct answer from the options given below:
Time of concentration (Tc) is expressed by the following equation
Following are the statements regarding grassed waterways:
(A) . The Manning's coefficient of roughness is 0.04 for design
(B) . These are designed to carry maximum runoff from a storm of 10 years recurrence interval
(C) . These are constructed across the land slope to remove excess water.
Choose the correct answer from the options given below:
What will be the overall efficiency of an ocean thermal energy conversion plant if the temperature of warm water in the
surface layer is 30°C and temperature of cold water in the depth of the tropical ocean is 8°C. It can be assumed that the
relative efficiency factor of the power plant is 0.5
A tidal power plant of single basin type, has a basin area of 25 x10° m2. The tide has a range of 10 m. The turbine however,
stops operating when the head on it falls below 2 m. What will be the energy generated in one filling process, in kWh if the
turbine generator efficiency is 75%. (Density of sea water = 1025 kg/m?)
Match List-I with List-II:
Choose the correct answer from the options given below:
Following are the statements regarding irrigation efficiencies.
(A) . Water conveyance efficiency is associated with the canal network
(B) . Water application efficiency is related with the irrigation method.
(C) . Economic efficiency is related with the overall performance of the irrigation system
Choose the correct answer from the options given below:
Select the Non-conventional energy sources from the following
Thermal vapour compression is used in
(A) . Evaporator
(B) . Homogenizer
(C) . Pasteurizer
(D) . Blancher
Choose the correct answer from the options given below:
Which one of the following has two-reversible isotherms and two reversible isobars?
Geothermal energy is used in India in the form of
(A) .Power generation
(B) .Space heating
(C) .Extraction and refining of borax and sulphur
(D) Refrigeration
(). Geomethanation
In light of the above statements, choose the correct answer from the options given below.
India is producing Geothermal energy in
Syllabus Chapters Breakdown पाठ्यक्रम अध्याय विभाजन
5 Chapters 5 अध्याय
Wind Power Physics & Betz Limit
Wind Power Physics & Betz Limit
8 Questions
Practice & Analytics →
अभ्यास एवं सांख्यिकी →
Bioreactor Transport Phenomena
Bioreactor Transport Phenomena
3 Questions
Practice & Analytics →
अभ्यास एवं सांख्यिकी →
Ocean & Marine Renewable Energy
Ocean & Marine Renewable Energy
2 Questions
Practice & Analytics →
अभ्यास एवं सांख्यिकी →
Enzyme Kinetics & Bioprocess Dynamics
Enzyme Kinetics & Bioprocess Dynamics
2 Questions
Practice & Analytics →
अभ्यास एवं सांख्यिकी →
Wind Energy Conversion Systems
Wind Energy Conversion Systems
2 Questions
Practice & Analytics →
अभ्यास एवं सांख्यिकी →
Official PYQ Papers
Previous Year Papers of Renewable Energy Engineering
Practice official shift-wise question papers with answer keys and detailed explanations on the actual exam pattern.
1
Total Available
Previous Papers